I dig the mag!
Lets see some cb's......
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
-
Thanks guys, the 750 is a custom built hardtail. The front half of the backbone and the down tubes were all I kept. The rest is 1 1/8th" tubing and 3/8" axle plates. stretch was about 5 1/2" and few other subtle cuts n welds here to get it like it sits. I also built the oil tank, batterie box, seat, seat pan, hinge , etc. Ported the head, dyna ignition, cycle x carbs, cycle x charging system, Cut the case covers...n more..? lots of time spent over the last few years. But it's taught me a ton! I love it, just rode 100+ miles down to Louisville , KY for the beatersville show. Interstate to back roads, it did amazing. Not a problem to get 80 + mph steady.
Parked next to this 70's SOHC molded sled. It was one of my most favorite bikes there:
Last edited by easyspeed; 05-28-2012, 3:34 PM. Reason: unicorn farts are what nag champa are made of...Comment
-
Comment
-
Comment
-
[QUOTE=haggard;330966]girder and 17 inch invader going on soon[/QUOTE]
I run a 17 on my Harman and love it. Its nice to see more people breaking away from the 21-23" wheels.Comment
-
300 mobile ad bottom forum
Collapse
Comment