Quick question on carbs

Getting ready to send my carbs out to get jetted and what not but I was getting ready take them off and I can't figure out how to get the fuckers off

Do i take them off from this screw?

If so, how the fuck do you get to it? its right up against the carbs so i can't get a driver on the screw head..

any help would be rad!

What is that a kz1000?

I have a kz650. The clamp screws were pretty hard to get at on it you just have to loosen the clamps on the rubber boots and then the carb rack should pull off.

DOHC Honda? I'd recommend re-jetting yourself, don't "send 'em off." Never know what somebody else thinks is a good idea to put in there. Plus it's REALLY EASY.

Originally Posted by CoyoteUSP

DOHC Honda? I'd recommend re-jetting yourself, don't "send 'em off." Never know what somebody else thinks is a good idea to put in there. Plus it's REALLY EASY.

its a kz1000 and the dude is legit! I was told to go to him by a member on here.

It is understandable to go with a legit person, but changing your jets out are easier than you could possibly think, I am pretty sure it is one of the tasks that hardley ever gets taken care of by someone else, especially someone else far away, where shipping is involved, really, just take off your bowls and your jets are there! andf it takes about one minute for each jet, or less time, for each jet! you really dont want someone else figuring out your carburation, who is not near by to do the task, at least! you might wind up with the wrong jets, lets say due to elevation, compared to where you are and where he is! and shipping could get toosed about and who knows what!!! you have a kz1100,, you lucky dog!!!! I really want I bigger bike like that or bigger!!! someday ! I will get a monster bike motor to put in to one of my chopper frames!!! along with all my leather werx, oh!!! that would be so awesome!!! you are a very lucky dude, so, try to keep it that way!!!! please do not take offense by the two of us who say, that jetting is easy,