CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: WillSCB

Page 1 of 19 1 2 3 4

Search Forums: Search took 0.02 seconds.

  1. Replies
    15
    Views
    438

    Final update. Swapped out the regulator/...

    Final update. Swapped out the regulator/ rectifier, and tracked down the electrical issue. Had a wire connected to the wrong spot and it was shorting out the lighting breaker. Got everything...
  2. Replies
    15
    Views
    438

    Quick follow up. After replacing the starter and...

    Quick follow up. After replacing the starter and having no luck, finally broke down and brought it to my buddy's shop to have him look at it. Apparently, I overlooked one of the first rules of...
  3. Replies
    15
    Views
    438

    Thanks much for the advise. I always appreciate...

    Thanks much for the advise. I always appreciate the in depth replies and information you post on here. Hadn't thought about the dielectric grease, but while I got the fairing off, it sounds like a...
  4. Replies
    15
    Views
    438

    Thanks, just relocated battery to under the seat...

    Thanks, just relocated battery to under the seat with a new 97 up battery (stock battery was under right side saddlebag. Convenient to access, but took 1/4 of the space from the saddlebag and put...
  5. Replies
    15
    Views
    438

    Found at least part of the problem. When I...

    Found at least part of the problem. When I touched the wire from the main breaker to the oil tank and grounded it, it appears that I shorted out the solenoid. Unplugged the relay and checked...
  6. Replies
    15
    Views
    438

    Been measuring voltage, and have it narrowed down...

    Been measuring voltage, and have it narrowed down to accessory and lighting circuits. As I said, I disconnect the orange wire going to the ignition switch I get voltage to "con" and ignition...
  7. Replies
    15
    Views
    438

    Electric issue.

    I know it's a chopper forum, but seeking the wisdom of some of the gurus on here. I am having an electric issue on my 1992 Electra Glide Ultra Classic. While doing something under the side panel, I...
  8. Replies
    10
    Views
    221

    If I am looking at your photo correctly, it looks...

    If I am looking at your photo correctly, it looks like the "shifter arm" that is coming directly off the ratchet top is in the wrong position. It should be up toward the seat or down toward the...
  9. Replies
    5,796
    Views
    3,473,066

    Thanks, taken at a local Tattoo shop that is...

    Thanks, taken at a local Tattoo shop that is owned by a buddy of mine. Here's another one, that I noticed after I had taken it it looks like the drawing of Lemmy has Marty Feldman eyes.

    103997
  10. Replies
    5,796
    Views
    3,473,066

    Couple photos from a photo shoot I did today. ...

    Couple photos from a photo shoot I did today. Managed to get a last minute sponsor and model for the "Lady of Sin" calendar girl feature on my website. No nudity in this shoot, but lovely lady...
  11. Replies
    5,796
    Views
    3,473,066

    Can't say for sure if she shot with him, but she...

    Can't say for sure if she shot with him, but she does not have a leopard print tattoo down her spine. She is a national feature performer who travels extensively, though.
  12. Replies
    5,796
    Views
    3,473,066

    Started this a while back on twitter after...

    Started this a while back on twitter after someone mentioned "Quarantitties" in a post, and decided to post some quarantitty posts on occasion. Figure I'll ad this site to that idea. I am going to...
  13. Replies
    271
    Views
    22,398

    Just a couple of quick shitty cell phone photos,...

    Just a couple of quick shitty cell phone photos, but went on a ride the other night, and was reminded why I love living here in the desert. Don't know why they came up sideways and upside down, so...
  14. Do yourself a favor and skip the helicoil and...

    Do yourself a favor and skip the helicoil and spend the extra money for a timesert (as long as there is enough room.) Timesert is a lot stronger and longer lasting solution. I only use a helicoil...
  15. Replies
    6
    Views
    501

    Not familiar with the harness you have or if it...

    Not familiar with the harness you have or if it uses factory colors or their own, but as far as the two wires to the module, I am thinking they go to the ignition pickup. You should have two wires...
  16. With everything cancelled for the near future....

    I decided it was as good a time as any to update my website. Site building software I use has a newer version available that I have been planning on updating to, but needed to be down for a bit to...
  17. Replies
    14
    Views
    590

    Check your service manual, but I am pretty sure...

    Check your service manual, but I am pretty sure that you need to line it all up with the front cylinder at TDC, and if you set it up on TDC at the rear, it will be 180 out.
  18. Replies
    139
    Views
    2,783

    Yeah, I'm alright. I got enough asswipe for a...

    Yeah, I'm alright. I got enough asswipe for a while, and I'm using the downtime from work to rework my website (sincitybiker.com) since it is an online motorcycle events calendar and there ain't...
  19. Replies
    139
    Views
    2,783

    And if you shit your pants it's too tight.

    And if you shit your pants it's too tight.
  20. Replies
    359
    Views
    10,341

    If I recall correctly, the Blue Flame 6 used...

    If I recall correctly, the Blue Flame 6 used mechanical fuel injection (might have been Hillborn, if not something similar.) As I understand, these are great if you are going from idle to WFO, but...
  21. Hey Lisa, thanks for this. I run...

    Hey Lisa, thanks for this. I run sincitybiker.com. It is a website that has a complete, up to date events calendar and information on motorcycle events and such in the Las Vegas area. Been hosting...
  22. Replies
    11
    Views
    493

    Among other things, the first problem I see is...

    Among other things, the first problem I see is the teflon head gaskets. Throw those worthless pieces of shit in the trash and spend the money for a decent set. I could never get those to last more...
  23. Jessie, I don't think I ever mentioned it in our...

    Jessie, I don't think I ever mentioned it in our conversations, but I kind of have a thing for the old Indians, thanks in part to my Grandfather. He had a full repair/ body/ machine shop in rural...
  24. Replies
    6
    Views
    561

    Not familiar with the Primo for sporties, but I...

    Not familiar with the Primo for sporties, but I can tell you that without major modifications, the Ironhead sporties all shared fluids between the transmission and primary, so a dry primary was not...
  25. Thread: EVO tappets

    by WillSCB
    Replies
    43
    Views
    1,907

    I just found out about the life of the roller...

    I just found out about the life of the roller bearings on evos the hard way. Got an Electra Glide Ultra Classic, and at about 53k one of the rollers went, and took the cam with it. It's a lot...
Results 1 to 25 of 459
Page 1 of 19 1 2 3 4

Log in

Log in