CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: JBinNC

Page 1 of 20 1 2 3 4

Search Forums: Search took 0.02 seconds.

  1. Replies
    2
    Views
    42

    On a decent runner that leaks, you need to look...

    On a decent runner that leaks, you need to look at the breather gear and the crankcase breather hose.

    If the motor makes decent power, and doesn't smoke or knock, just replacing the gaskets and...
  2. Replies
    18
    Views
    338

    The XL cups I have, have a shank OD of 1.189 -...

    The XL cups I have, have a shank OD of 1.189 - 1.194. In fractions that would be 1 3/16.

    Jim
  3. Replies
    18
    Views
    338

    Looks like a typical bored XL steering head with...

    Looks like a typical bored XL steering head with a chamfer to me.

    Jim
  4. Replies
    18
    Views
    338

    All the K and XL frames had the same ball bearing...

    All the K and XL frames had the same ball bearing cups from '52 to '78 I think, and the' 79 and '80, and maybe '81 had a Timken set that fit in the frame the same way. If your buddy ordered cups for...
  5. Replies
    18
    Views
    338

    You do realize that the cups are a press fit? Two...

    You do realize that the cups are a press fit? Two or three thou press, unless the frame is stretched. You will need to drive them in, or draw them in with a tool made for the purpose.

    Jim
  6. Replies
    2
    Views
    75

    That's the stuff. Jim

    That's the stuff.

    Jim
  7. Replies
    22
    Views
    555

    There are still motorcycle magazines? Jim

    There are still motorcycle magazines?

    Jim
  8. Replies
    6
    Views
    154

    You can run the motor as long as you please with...

    You can run the motor as long as you please with the regulator unplugged from the stator. That bit of advice from a manual is just BS.

    Quick and dirty way to check the stator for output is to hook...
  9. Replies
    6
    Views
    154

    The 22 amp upgrade will not cause you any...

    The 22 amp upgrade will not cause you any problems.

    Jim
  10. Replies
    6
    Views
    154

    There have been a number of alternators from H-D...

    There have been a number of alternators from H-D since their introduction in 1970. At least four of those systems can be installed in shovelhead cases. Fortunately, each system has a unique...
  11. Replies
    14
    Views
    324

    A fully charged, new AGM battery should read...

    A fully charged, new AGM battery should read 12.8V. That figure will drop as the battery ages. If your new battery only readv12 5V, it was not fully charged.

    You say the starter is "slipping." If...
  12. Replies
    3
    Views
    148

    Yeah, the key is there to keep that spacer...

    Yeah, the key is there to keep that spacer turning in the event that the sprocket nut works loose, and that happens quite often.

    Jim
  13. Replies
    3
    Views
    148

    They just eliminated the key. You can run either...

    They just eliminated the key. You can run either style because otherwise the spacers are the same.

    Jim
  14. Replies
    5
    Views
    182

    Yes. Jim

    Yes.

    Jim
  15. Replies
    5
    Views
    173

    I would think it has to do with the fittings on...

    I would think it has to do with the fittings on the oil pump and filter, yes.

    Jim
  16. Replies
    5
    Views
    173

    The evo motors all mount the same, and apart from...

    The evo motors all mount the same, and apart from a few details, are functionally the same, '84 - '99. In the evo big twin line, the later the motor, the better.

    Jim
  17. Replies
    14
    Views
    324

    Battery and cables first. Do some checking with...

    Battery and cables first. Do some checking with your voltmeter and you should be able to narrow it down.

    Jim
  18. If the battery is slowly losing its charge (as...

    If the battery is slowly losing its charge (as stated, over a few days) then the most likely cause is an alternator that is not charging the battery, or at least, not charging enough to keep the...
  19. No, you cannot "bypass " the electronic ignition....

    No, you cannot "bypass " the electronic ignition. You have to have some kind of ignition. There are simpler systems (as touched upon in this thread). You will always have a coil, a pickup, a module,...
  20. Replies
    19
    Views
    400

    Arm pictured is for the tin primary. The arm for...

    Arm pictured is for the tin primary. The arm for the aluminum primary is shorter, and the clutch rod goes inboard of the solenoid. I don't know if you can fit this stuff up, if you have the cowpie...
  21. Replies
    22
    Views
    551

    Five hunnert dolla bike, in my opinion. You...

    Five hunnert dolla bike, in my opinion.

    You pay the five hunnert for the privilege of spending several thousand on it. Your call, but at the asking price I wouldn't even look at it.

    My 2c...
  22. Replies
    5
    Views
    288

    I can do a set of shovel heads for a little more...

    I can do a set of shovel heads for a little more than half the S&S new price. But the Ultima heads are much cheaper, and reportedly pretty good.

    Jim
  23. Replies
    5
    Views
    288

    Oil in a shovelhead combustion chamber most often...

    Oil in a shovelhead combustion chamber most often comes from a head gasket leaking from the oil return passage to the chamber. That is very common. Second most common cause is worn valve guides and...
  24. Yes, it will work on evos that had the 32 amp...

    Yes, it will work on evos that had the 32 amp stator as original equipment, because the mount area in the case is deeper, allowing room. It will NOT work in a shovel case with a 32 amp stator. (The...
  25. You cannot squeeze that rotor into a shovel with...

    You cannot squeeze that rotor into a shovel with a 32 amp stator. The chain or belt would never line up. The drawn cup rotors are all you can use.

    Jim
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Log in

Log in