CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: TriNortchopz

Page 1 of 20 1 2 3 4

Search Forums: Search took 0.03 seconds.

  1. Replies
    70
    Views
    659

    Have you confirmed the points gap and the proper...

    Have you confirmed the points gap and the proper timing? Since there was an electrical short in the lighting system which affected your ignition, I would temporarily eliminate all other wiring from...
  2. Replies
    629
    Views
    218,049

    95812 95813 95814 95815

    95812

    95813

    95814

    95815
  3. Replies
    2
    Views
    102

    What about replacing that straight swingarm for...

    What about replacing that straight swingarm for an earlier triangular-shaped one, like from a '82 XT250 - give you a more traditional-looking hardtail:

    95798...
  4. Replies
    70
    Views
    659

    Could be your meter can't read that low (about...

    Could be your meter can't read that low (about 0.2 oms), a Rx1 scale would pick it up.
    To check to make sure wire is not broken, try running 12 volts through it from your battery...touch one end of...
  5. Some nice parts here you could include in your...

    Some nice parts here you could include in your build, or give you ideas to fab your own stuff:

    Classic British Motorcycle Speed Equipment
    95761
    95762...
  6. This blog looks to be inspirational - although...

    This blog looks to be inspirational - although for a pre-unit, some nice stuff:

    Tim's Triumph bobber build
    http://trojanclassics.blogspot.com/2010/12/tims-triumph-bobber-build.html
  7. To get the most out of your 650 twin engine, here...

    To get the most out of your 650 twin engine, here is some info:

    Technical Information Bulletin No. 14
    Preparation an Assembly of Unit Construction 6T, TR6 and T120 Engines for Maximum Performance...
  8. Replies
    70
    Views
    659

    remove cap, one lead of multimeter on each end,...

    remove cap, one lead of multimeter on each end, set on lowest range, as the solid core wires should have close to zero resistance. Then check each cap; may have resistor caps, typically 5K ohms.
    ...
  9. Replies
    70
    Views
    659

    Not too much to it: The contact breaker...

    Not too much to it:

    The contact breaker (points) ignition system
    95750
    diagram of 1959-1978 Harley Davidson Sportster ignition system.
    "...While the contact breaker is “closed” or connected to...
  10. And for info on the t120,a '69 model (just a few...

    And for info on the t120,a '69 model (just a few changes in '70 - primary shares engine oil, gearbox upgrades...):

    The Bonnie Ref

    A Hyperlink Junkie's Illustrated Field Guide
    to the 1969...
  11. Heard good things about this 4-chapter DVD; "This...

    Heard good things about this 4-chapter DVD; "This guy was employed by the Triumph Engineering Co. (Meriden) from 1953 -73. The DVD walks you through total strip down and rebuild. A must have."
    ...
  12. Replies
    70
    Views
    659

    Sounds like ya got enough volts. Easy way to...

    Sounds like ya got enough volts.
    Easy way to check spark is to pull the plugs, connect them to the plug caps like normal, lay them on the head, turn on ignition, then manually open the points....
  13. Replies
    12
    Views
    168

    Thanks to Sky for sharing his knowledge, the...

    Thanks to Sky for sharing his knowledge, the internet and ChopCult!
  14. Replies
    12
    Views
    168

    In this 2015 thread; Thread: shovelhead build no...

    In this 2015 thread; Thread: shovelhead build no oil flow

    Sky had a good comment:

    "One, make sure all your oil lines are correct
    Two, pull all the caps, two on the pump and the tappet as well...
  15. For sale 1947 FL knucklehead motor completely...

    For sale 1947 FL knucklehead motor completely rebuilt clean title 6-month warranty $15,000 Rob White @ 703-476-6607
    95664
  16. Replies
    19
    Views
    466

    95651 check the couple of links I just dropped...

    95651

    check the couple of links I just dropped in vwlord's gs thread...
  17. Thread: My gs850

    by TriNortchopz
    Replies
    4
    Views
    158

    Seen these? Big list of Suzuki gs...

    Seen these?

    Big list of Suzuki gs chop/bob/brat
    http://www.chopcult.com/forum/showthread.php?t=11692


    Search Forums: Tag: suzuki

    http://www.chopcult.com/forum/tags.php?tag=suzuki
  18. Replies
    19
    Views
    466

    Check out frame mods on this GS: 95637 95638

    Check out frame mods on this GS:
    95637
    95638
  19. Replies
    2
    Views
    167

    You didn't say which '95 model ya got, so I...

    You didn't say which '95 model ya got, so I guessed; Is your shifter setup like this:
    95570...
  20. can you post a few pics? include a side view.

    can you post a few pics? include a side view.
  21. Replies
    2
    Views
    177

    Some are a little easier than others...looked at...

    Some are a little easier than others...looked at a parts image of your clutch actuator:
    95535
    https://www.bikebandit.com/oem-parts/1981-honda-900-super-sport-cb900f/o/m151801#sch401850

    I see the...
  22. Replies
    11
    Views
    350

    Here is a link to that article: A look at 1970s...

    Here is a link to that article: A look at 1970s Softail Chopper Frames by Andrew (Prof) from Choppers Australia:...
  23. Replies
    11
    Views
    350

    Again, not Amen, as they got axle in middle of...

    Again, not Amen, as they got axle in middle of the springs:
    95528

    Looks like Santee softail, or a plunger frame by The Machine Shop:
    95529
    Santee
    95530

    95531
  24. Replies
    46
    Views
    2,248

    how about some pics of the frame so we can see...

    how about some pics of the frame so we can see the tubes you are talking about, and a hand drawn sketch (or CAD) of your plan. That'll help with thinkin' thoughts...

    Is it anything like this...
  25. Replies
    1
    Views
    85

    What make and size carbs on there? got a manual?...

    What make and size carbs on there?
    got a manual?
    find a pdf version online.

    what about parts book?
    https://www.kawasaki.com/Parts/PartsDiagrams/1974/KZ400-D

    Maybe something here:...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Log in

Log in