PDA

View Full Version : Single Carb Side Draft for Triumph. Anyone make one?



justice66
12-16-2010, 6:09 PM
I've got a OIF Triumph thats hardtailed and i dont have much room for an aircleaner so I want to put the carb on a bit of an angle so i can run a different air cleaner than the pancake style. Does anyone make an offset carb adapter or sidedraft that bolts to the intake? I have a single carb with amal flange.

66triumph
12-16-2010, 6:32 PM
I have one on my bike, but it's for spigot mount carbs. if you want, I can give you the contact info.

-A.

justice66
12-16-2010, 7:39 PM
Thanks A. I PMed you yesterday about it. I checked out that guys stuff. Its cool but i dont have a spigot mount

LinkBelt
12-23-2010, 9:40 PM
Check this out man, If you can get your hand on a set of webco manifolds and a stock triumph single carb manifold you can bolt them all together and it will make a single side draft manifold and it works. :cheersmate:

Wonka
12-23-2010, 11:48 PM
look up http://www.cobbcustoms-onewayracing.com/ this guy got some bad ass set ups

UNKLian
01-02-2011, 10:23 AM
What sort of angle do you want ? 90 ? 60 ? 45 ? 30 ?

justice66
01-04-2011, 10:12 PM
probably 45 or 90

Tyler
01-05-2011, 10:11 AM
This is what it sounds like you are looking for Cobb side-draft manifold for Triumphs (http://www.cobbcustoms-onewayracing.com/), though set up to use a Mikuni. I have a friend who runs one and loves it. The website sucks, but there you go!

UNKLian
01-05-2011, 10:59 AM
I'll be making them for Amals, 45 or 90 degrees, in cast Aluminum.

Should be ready by Spring.

justice66
01-07-2011, 9:43 PM
Im thinkin im going to make one out of steel for now. It will take some time but i think i can do it