PDA

View Full Version : Kim Boyle Help...best throttle/front master cyl/levers for sr500



Suicidal87
12-11-2010, 10:44 PM
Looking to clean up my bars, whats the best route to go as far as throttle and levers? I was looking at an mx setup, similar to Kim Boyles...where can a cop this setup or somthing similar? And where did he relocate the decomp lever?

http://image.streetchopperweb.com/f/29173280+w750+st0/1008_stcp_04_z+1981_yamaha_sr500+handlebars.jpg

motorlou
12-11-2010, 11:19 PM
not much help with master cyl./caliper combos but if you are going to run a front brake i would set it up like the link below vs. running a master on the bars......

http://www.youtube.com/watch?v=StWi3HZJw28

thelowlife
12-12-2010, 7:46 PM
Any details on that setup?

motorlou
12-12-2010, 7:52 PM
what would you like to know? i just ran a dirt bike lever with a chopped down bike brake cable to a nissin master cyl., the master cyl. was a rear master cyl. off of some honda i found at a junkyard. it is really super basic to set up. rather than have a foot pedal to activate the master cyl. you are doing it via cable.