PDA

View Full Version : need a measurement for a fx front end



boynamedsue666
09-10-2009, 12:16 AM
Does any one have a manual for fx models 76-83? I need the measurement for a stock crush spacer(axle spacer) for a dual disk front end. The one I have I think is a smidge to big.
Also. The while ya have that manual out..could I get the torque spec for the allen in the bottome of the slider.
And how in the hell do I get that thing torqued down with out the leg spinnin. I have the top cap on and im puttin pressure on the slider while I tighten(im using a dewalt corded drill with a allen). But when I turn the leg right side up it seems like it still wants to seperate a lil...like a 1/4" of play when the leg is fully extended and then pulled on.
Am I makin any sense?

wuzfuz
09-15-2009, 8:03 PM
The only specs I find are as follows:
spacer
2.564 violet
2.550 pink
2.536 gold

spacer between bearings
2.162 red + white
2.177 green + orange
2.148 gold + violet

I couldn't find a torque spec for drain plug
Hope this helps...WUZFUZ