PDA

View Full Version : Triumph wiring and cover



TroyFab
08-11-2010, 8:47 PM
Red wire (power) on left and Black wire all grounds on right:
http://i166.photobucket.com/albums/u89/troyfabrication/Triumph%20Build/por-15001.jpg
Bored a hole in some aluminum angle iron and then cut out the end:
http://i166.photobucket.com/albums/u89/troyfabrication/Triumph%20Build/por-15004.jpg
http://i166.photobucket.com/albums/u89/troyfabrication/Triumph%20Build/por-15005.jpg
Quick fin job:
http://i166.photobucket.com/albums/u89/troyfabrication/Triumph%20Build/wiringcover001.jpg
Mounts to plate I put in there to run the terminal strips, and I pre drilled the holes to make it easy when I finally got around to making this:
http://i166.photobucket.com/albums/u89/troyfabrication/Triumph%20Build/wiringcover002.jpg
JUst need some buffing.

Torch
08-11-2010, 11:59 PM
clean work, and using circuit breakers is the way to go. good job

deadbird
08-12-2010, 3:17 PM
Pretty slick! Clean and simple.

BSAJimbo
08-12-2010, 8:16 PM
Looks nice!

BitMonkey
08-15-2010, 4:46 PM
Indeed. Killer idea and execution.