View Full Version : Springer question

09-03-2017, 12:23 PM
Having a hard time figuring this..have a frame (stretched and lowered) but figured it for an 8 over springer...ended up with a 10 over...now frame sits a bit too high. Want to lower it without rewelding...its at 38 degrees now. Suggestions?

09-03-2017, 1:20 PM
it's a rigid frame, right?
Flip or swap the rockers? Custom axle rockers are a common way to dial in trail
Never seen those Aladdin shoe type? 4hey can drop that front end significantly...

Or maybe a taller rear wheel/tire combo? Maybe

09-04-2017, 2:44 PM
Picture would help. Have you ridden it yet ? If it's not too far up it will still ride good and give you extra ground clearance. Raked cups could help depending what kind of springer it is.