PDA

View Full Version : Paugcho 4 speed belt drive frame Question



Holyschmidt
06-19-2017, 3:48 PM
Hey everyone quick question, I have a rigid paunch frame for a shovel/pan and was told it was for a chain drive but upon arrival it is most definitely for a belt. Is it ok to still run a chain drive in a belt frame? minus the little bit off center the rear wheel/ fender would be? Thanks

tzienlee
06-19-2017, 5:28 PM
Always run the wheel centred to the frame.!!
move the rear sprocket to line the chain up with the transmission sprocket using spacers...or dished sprockets if needed

Tattooo
06-19-2017, 5:36 PM
Hey everyone quick question, I have a rigid paunch frame for a shovel/pan and was told it was for a chain drive but upon arrival it is most definitely for a belt. Is it ok to still run a chain drive in a belt frame? minus the little bit off center the rear wheel/ fender would be? Thanks


Think if it this way.... Does your frame know whether it has a chain or a belt???? No............ As long as it's not rubbing and is running straight run it..... If it bothers you change it..... Plain and simple....

Holyschmidt
06-19-2017, 7:31 PM
Thanks for the advice, if I choose to run this frame thats the route I'll go.