PDA

View Full Version : Starter Solenoid Wiring Question



bellam87
02-21-2016, 8:28 PM
I've noticed after wiring up my chop that the universal solenoid I purchased has to have the 4 wires on the top in a certain order or else is pops the fuse. The solenoid is a 30 amp model with 4 male pins (2x2) on the top. I'm wondering if anyone on here can tell me where each of the wires are supposed to be on the solenoid. By the way I used the wiring diagram and solenoid provided below.

67354
67355

sdustin
02-22-2016, 1:25 AM
I think it's one ground wire and three hot wires. The solenoid should have come with a diagram?

bellam87
02-22-2016, 5:47 PM
No it didn't come with a diagram. I was hoping somebody had used this model and could identify the terminals.

trikerdrew
02-23-2016, 7:03 PM
Multi meter would suss it out.

In general bike wiring the positive wires are female on the end to avoid them shorting

Drew

farmall
02-27-2016, 10:51 AM
You can use a blade style circuit breaker instead of the fuse. I hate fuses. 30A will do from any auto store. Bring sample fuse to get correct breaker.

That style relay is very common on Hondas but for whatever reason I'm not seeing a useful diagram on the internet. I just map them with a test light on whatever bike I'm working on.

The fuse and one or two (I forget which and don't have a relay lying around at home) blades fed by the fuse will be constant hot with battery connected. Use one constant hot to feed you key switch.

One of the non-hot blades should be a relay case ground and the other should accept switched power to operate the relay.

Sky
02-27-2016, 4:04 PM
67430