PDA

View Full Version : trouble syncing my carbs



justin666
08-17-2009, 7:14 PM
I've got a 1981 kz650 and i just adjustied the needle jets so it'll run a bit richer( i've got pod filters)

but now that i've got everything back together i'm having a hard time syncing up the carbs. I've done it before with out any problems and i've got a carb syncer but for some reason this time its being a real pain.

any tips or anything i should try?? thanks



i know this is a real vague post and i'm sorry.haha

eightthirtysixcc
08-17-2009, 8:29 PM
Bench sync it first. Off the bike make sure all the slides are the same height. Make extra sure you set all the needles to the same height. Make sure none of the slides are hanging up. Keep the rpm at 900-1000.
It can be a bitch sometimes, make sure it is on the center stand (to keep the gas in bowls the same height). Get it to operating temp first, then put a fan on the fins.

It could be a million different things and it's hard to diagnose over the internet.

This is why all the guys like Harley Davidson, one carb!

justin666
08-17-2009, 9:40 PM
alrighty i'll try bench sync first. I dont have a centerstand but i put a 2x4 under the kickstand so the bike is more level.

Fucking A right. i need to get me some american haha