PDA

View Full Version : swingarm pivot bushings



swellguy
04-19-2010, 3:29 PM
The swingarm was a bit dicey on my 73 cb750 so I finally took it all apart and found that there were no swingarm pivot bushings in the setup:
http://i294.photobucket.com/albums/mm86/swellguy_album/229.jpg
The center collar was there but as I say no pivot bushings.
I have a new set of pieces and want to put it together. My pivot bushings don't have the lip as shown in the above illustration. I have the earlier setup with felt caps etc,
My question is are these press in fittings?