PDA

View Full Version : 41mm to 39mm on 77' 4 speed frame



TroubleLeather1
08-08-2009, 9:53 PM
ok call me a dumbass but, is there anything i should know like bearing changes, the stem on the 39 being too long/short? or any changes i would have to do to accomadate the narrow on my 4 speed frame? it's an 02' narrow glide. and also i have a spool hub from flyrite and a 21'' rim, anybody know what size spokes i need? thanks for the tips and putting up with my stupidity :)

Fredo
08-10-2009, 11:55 AM
It should bolt right up, not sure on the spokes.

Joey
08-10-2009, 12:10 PM
You could get ahold of Flyrite on the spokes. It's their hub, they oughta know.

Front end oughta go right on. Look at the stem of the one you take out and the one you are putting on. If they look the same then you are fine.

Look at the bottom trees too... Will the fork stops be OK? You'd hate to put that fucker on there and dent the tank cause shit didn't line up.

Clutch
09-21-2013, 1:38 PM
this was the 4th post from the first post. did you figure it out yet Chris!