PDA

View Full Version : question about float bowl screw



04chopper
04-06-2011, 6:13 PM
What's the best way to adjust the float bowl screw on a S&S E

vnygra
04-06-2011, 6:14 PM
With a screw driver

vnygra
04-06-2011, 6:15 PM
Sorry man. Too easy. I can only dream of an s&s while trying to get my bendix to not leak

RichL
04-06-2011, 6:49 PM
to adjust float level?

take the bowl off and raise the float to max height, if its above the overflow tube bend the float rod slightly until it sits just below the overflow tube. This is seriously the factory s&s procedure for adjusting float level.

if your bike is running rough, change jets. s&s carbs are super easy to tune.

and that float bowl screw on the bottom of the carb is to drain gas before you take the bowl off.

04chopper
04-06-2011, 6:51 PM
Thanks man