|
| Account Type: | ChopCult Members |
| Network: | Default |
| Profile Views: | 2271 profile views |
| Friends: | 8 friends | | Updated: | 3 week(s) ago | | Signup Date: | January 8, 2011 |
|
|
About Me
|
City:
|
|
|
Country:
|
|
|
Motorcycles:
|
|
|
Project Bikes:
|
|
|
Profession:
|
|
|
Birthday:
|
(33 years old) |
|
Gender:
|
|
|
Website:
|
|
Recent Activity
 |
2 week(s) ago
Stabler made a post in this thread: Need help: FX 77-83 neck, front end and wheelI dropped the wheel of at the local Harley shop again. I figured it's theirs fault since there's only one way to mount the wheel, it can't really be my fault the bearings has collapsed after 300 miles. Luckily I didn't crash..
I've also found t...
|
|
2 week(s) ago
Stabler made a post in this thread: 77 cb750 carb helpI assume you have the right intake boots? The 77-78 ones is shorter and kind of hour glass shaped compared to the earlier ones. You need to have the right ones..
|
|
2 week(s) ago
Stabler made a post in this thread: 77 cb750 carb help[QUOTE=murph18;493318]I changed to 120 jets and had the same problem, so a buddy and I put the stock airbox back on and it ran like a champ. So I put the pods back on and bought some 125 jets. I finally took it out tonight and it runs like it shou...
|
|
2 week(s) ago
Stabler made a post in this thread: Need help: FX 77-83 neck, front end and wheel[QUOTE=bobscogin;492921]I always set preload on the bench before I install the wheel. Before you install the seals, put the dry ungreased bearings in place and push the axle through them. Make a spacer that slips over the threaded end so that you ...
|
|
4 week(s) ago
Stabler posted a comment on mattxxx's classified listing:I got that. Was just wondering since I have my lower setup already shaved and done with brakes etc.. Will you ship to Sweden? If the shipping rate isn't ridiculous? Could you check what the additional shipping cost would run up to - or is that to...
|
|
4 week(s) ago
Stabler made a post in this thread: 1978 Honda CB750K build thread.That is a CB750 after market reg/rect. I'm 99.9% sure of it. I've got one that looks exactly like it on my chop. I't looks like it's already wired to your CB750? Doesn't it work or were you just curious as of what it came of from?
Awesome bikes...
|
Photo Albums (1)
|
Updated 1 year(s) ago
Pictures of my build - from scratch to Bobber.
(I'll get mor...
|
Classifieds (1)
|
Posted: 4 week(s) ago
I need to get my greasy paws on a set of 6" over Showa 35mm fork tubes. Good used condition is OK.I really need to get that front up some. The thing is I...
|
|
|
|
