 |
Dragstews this site is about bike builds.. not back talk or some place to make waves like chop cult...
Updated: 8 month(s) ago
|
|
|
| Account Type: | ChopCult Members |
| Network: | Default |
| Profile Views: | 16558 profile views |
| Friends: | 24 friends | | Updated: | 2 month(s) ago | | Signup Date: | September 20, 2010 |
|
|
About Me
|
City:
|
|
|
State:
|
|
|
Country:
|
|
|
Motorcycles:
|
|
|
Project Bikes:
|
|
|
Profession:
|
|
|
Birthday:
|
(67 years old) |
|
Gender:
|
|
|
Website / Social Media:
|
www.dragstews.com
|
Recent Activity
 |
4 week(s) ago
Dragstews posted a comment on Dragstews's classified listing:OK ...To sweeten the deal, will throw in a manifold of your choice.Either a Pan O-Ring or a Shovel O-Ring ... Both are S&S ...
|
Photo Albums (1)
|
Updated 8 year(s) ago
Here are a few Builds that was done by me...Mostly only do motor builds....
|
Classifieds (20)
|
Posted: 5 month(s) ago
Jugs have been bored .030" over and looks like it wasn't so very long ago. The crank is all in one chunk and was pulled from a 1974 XLCH running motor ....
|
|
|
Posted: 6 month(s) ago
+ the Ride I bought this to use on my 52 Pan/Shovel chop, after it came in found out that it was way bigger than it looked like in the photos ... Love the l...
|
|
|
Posted: 6 month(s) ago
This is new, the carb is not in the deal it's listed in another ad.
|
|
|
Posted: 6 month(s) ago
+ Ride Did a clean up, install a new Bendix pump. new gasket, later design float & needle ... In great shape, ready to run ..
|
|
|
Posted: 7 month(s) ago
Fit 90 and up . Compete with clutch and outside bearing support . Chrome is not in the best of shape, could stand some loving in that area... Hey ... I go...
|
|
|
|
